Quote:
Originally posted by MadDogMe
Volenti!  : How does your micro pin block(or current best?) perform compared to your 'direct~die~jet block' you had before?...
|
Oh the temp readings are impossible to compare between the intel system thet the direct die setup was on and the AMD system I'm using currently.
however I made a base up for the direct die block and tried it up against my micro pin block;
(note those are 9 holes in the base, not divots)
it (as best I can measure) matches my micropin block, I have made another block with just one intake/exit and 9x2mm jet holes (verses 9x1.5mm) that better suits the pumps most commonly used, it is predictibly slightly lower performing (by ~1.5 degrees) but "adequate" for the job, I'm currently still using it since it makes the plumbing cleaner in my case.