Pro/Forums - View Single Post

leejsmith · 04-03-2003, 12:35 PM

so i rushed home from work today after the akasa base was deliverd and this is what i have so far.

i still need to do some sanding to get rid of some of the ridges left from the fins. the fins cover a p4 heat spreader and are 5mm high from the top of the base. the base is 3mm.

here you can just make out the groove i have cut into the base. i think it's about 1mm at the moment. it's a bit trickey and if i am not careful i could remove one of the fins.

next the top with jet, but i will leave that for tomorrow night.

if i compare this or the version 1 to my koolance exos system will that be a good indication how good it works ? will the fact that it's not the same rig (pump , rad , tube size) make the readings i get useless.

04-03-2003, 12:35 PM	#55
leejsmith Cooling Savant Join Date: Mar 2003 Location: notts uk Posts: 408	so i rushed home from work today after the akasa base was deliverd and this is what i have so far. i still need to do some sanding to get rid of some of the ridges left from the fins. the fins cover a p4 heat spreader and are 5mm high from the top of the base. the base is 3mm. here you can just make out the groove i have cut into the base. i think it's about 1mm at the moment. it's a bit trickey and if i am not careful i could remove one of the fins. next the top with jet, but i will leave that for tomorrow night. if i compare this or the version 1 to my koolance exos system will that be a good indication how good it works ? will the fact that it's not the same rig (pump , rad , tube size) make the readings i get useless.