Quote:
Originally posted by g.l.amour
what i was wondering about:
max; how did you manage to narrow down the inlet barb?
|
Well it comes with a 1/2 inch hose tail and narrows down to 7mm. I usually drill them out to 10mm ID but got one that i hadn't drilled out yet.
I made one that had a grid of holes but it performed about 3 C worse than than the one above with just one 7mm jet. Probably because of my 1048 pump. When i had the pump in the open the 7mm would travel much further and faster than my multihole jet one.