Pro/Forums - View Single Post

Gulp35 · 04-04-2003, 06:58 AM

Hi guys,
I was planning on building one of these block but first I was going to see if it would perform better than my simulated channel block. Using the Cryoterm (I think that is the place) jet impingement calculator I would find out and compare the H values. But I don't know how much pressure drop the block would create.

Volenti, perhaps you could measure the flow through the block and guestimate how much pressure drop, thanks.

If it helps my design would be using 7, 1.5mm diameter holes.

04-04-2003, 06:58 AM	#67
Gulp35 Cooling Savant Join Date: Sep 2002 Location: Atlanta, GA Posts: 135	Hi guys, I was planning on building one of these block but first I was going to see if it would perform better than my simulated channel block. Using the Cryoterm (I think that is the place) jet impingement calculator I would find out and compare the H values. But I don't know how much pressure drop the block would create. Volenti, perhaps you could measure the flow through the block and guestimate how much pressure drop, thanks. If it helps my design would be using 7, 1.5mm diameter holes. __________________ Epox 8RDA+ v1.1----------Tyan K8SDPro 1700+ JUIHB 0310XPMW (12.5x200Mhz@1.792v)--------2xOpteron246 (2Ghz 1MB L2) 2x256MB Kingston PC3000 (BH5?) 2-2-2-8 2.7v---2x512MB Corsair Reg.&ECC PC3200 ATi Radeon 9800Pro (stock, too hot)-----ATI RageXL WD800JB+WD2500JB-------WD1600JD Sony DVD/CDRW-------NEC 3520A Black Forton350W--------Antec TruePower2.0 550W EPS12v