[Balinju]

Thank you utabintarbo.

Now just a little update on how the work is going. The aluminium is bought, i bought 32cmx6cmx8mm so that i can construct 4 blocks.

I also bought the xy table and a 1 x 1mm bit and 1 x 5 mm bit.

now i am planning to do the following constructs.
Block1: 4mm base : 4mm deep channels
Block2: 3mm base : 4mm deep channels
Block3: 3mm base : 3mm deep channels
Block4: 2mm base : 4mm deep channels

All these blocks are going to be milled out in al

Any suggestions/comments before i start milling??