Pro/Forums - View Single Post

babyeater · 04-04-2003, 01:47 PM

I am soldering up a Rotor style block tonight . It is made from 10mm copper with 4mmholes with .5mm spacing between the holes. I used a square and a scribber to mark the hole positions. I am going to try one with 3mm holes and .25mm spacing to see if it performs any better. I am going to use the templete located below
http://www.geocities.com/dr_babyeater/
Its not to scale tho.

04-04-2003, 01:47 PM	#51
babyeater Cooling Neophyte Join Date: Sep 2002 Location: Ireland Posts: 42	I am soldering up a Rotor style block tonight . It is made from 10mm copper with 4mmholes with .5mm spacing between the holes. I used a square and a scribber to mark the hole positions. I am going to try one with 3mm holes and .25mm spacing to see if it performs any better. I am going to use the templete located below http://www.geocities.com/dr_babyeater/ Its not to scale tho.