Pro/Forums - View Single Post - Copper Plate Rad dimensions/performance/etc?

Gulp35 · 04-05-2003, 09:28 AM

I'm from Marietta, West Cobb more exactly, but it would cost 70$ to buy the metal.

I my idea each radiator cell would consist of 2 plates and glued soldered, etc. between them would be metal strips to direct the flow. I was going to make this to fit in the front of my case( lianLi PC60) and do this by making 10 6X7in. plates and stack them 3mm. apart.

I'm not sure if you have read it, but there is an article about making this type of radiator on Overclockers.com in the watercooling section. I think it was called "more radiator, less noise" but i'm not sure

04-05-2003, 09:28 AM	#12
Gulp35 Cooling Savant Join Date: Sep 2002 Location: Atlanta, GA Posts: 135	I'm from Marietta, West Cobb more exactly, but it would cost 70$ to buy the metal. I my idea each radiator cell would consist of 2 plates and glued soldered, etc. between them would be metal strips to direct the flow. I was going to make this to fit in the front of my case( lianLi PC60) and do this by making 10 6X7in. plates and stack them 3mm. apart. I'm not sure if you have read it, but there is an article about making this type of radiator on Overclockers.com in the watercooling section. I think it was called "more radiator, less noise" but i'm not sure __________________ Epox 8RDA+ v1.1----------Tyan K8SDPro 1700+ JUIHB 0310XPMW (12.5x200Mhz@1.792v)--------2xOpteron246 (2Ghz 1MB L2) 2x256MB Kingston PC3000 (BH5?) 2-2-2-8 2.7v---2x512MB Corsair Reg.&ECC PC3200 ATi Radeon 9800Pro (stock, too hot)-----ATI RageXL WD800JB+WD2500JB-------WD1600JD Sony DVD/CDRW-------NEC 3520A Black Forton350W--------Antec TruePower2.0 550W EPS12v