sorry guys but i am in intel fan. it goes back to when i used to build 486 pc's and we had some amd chips. Every one i built came back to the shop.
anyway i have had a busy weekend and here are the results. I did loose a couple of the fins along the way.
this is the new block before i bond the to acrylic pieces together and polish the sides.
here is the base with the channles cut and the height of the fins and the depth of the channels
if i had a better way of cutting the channels i would try and go a little deeper.
this is the middle acrylic layer i used the dremel bench to cut the middle away and also the jet in the center.
you can see the channel i cut into the inlet to cover the jet.
and here the jet in action.
once i clean it up and seal it i will do some tests against my other block and the koolance exos i have.