Quote:
Originally posted by Blackeagle
I hope the block top gets there soon. Sent it by air to try to hurry it along.
Instead of a plastic tube in place of the threaded barb, how about use of some 1/2" copper or stainless steel tube. Plastic tube would both have thicker walls and break more easy. Just rough the outside of the tube a bit with some 400 grit paper to give a bit of extra grip to some epoxy resin/glue. Much stronger and will give maximum flow. You also might wish to rough the area of the tube where your tygon will be clamped on, again for grip.
I think you'll find this would work quite well.
I would hope the Lexan should be there by end of this week.
|
i have the lexan so will start work as soon as i can.