View Single Post
Unread 04-10-2003, 07:58 PM   #50
jaydee
Put up or Shut Up
 
jaydee's Avatar
 
Join Date: Dec 2001
Location: Spokane WA
Posts: 6,506
Default

here is the sneak peak at REV 4.0. Note the base and top is not finished. About 1/2" on both sides worth of pins will be milled down on the top and base. I am going to leave about 3/4" worth of pins in the center. these pics do not do it justice though. hard to get a good pic of them. these pins are twice the size of the REV 3.0 pins and the pin higth is also deeper I am a little of 1/16" deep in the 1/8" base.






Got a lot of work left to do on it. I am test running my micro channel block now after its revision with the channels milled into the top.
jaydee is offline   Reply With Quote