I thought you'd found the fans!, thought you'd found a Papst dealer?. Have you got a link handy to the place?, my HD's been reformated a few times since then!. It was a place in Andover was'nt it?. I'll mail them for the price but the exchange rate will crucify you
. I opted out for some YSTechs but they have an anoying tickety~click noise even at 5Volts. I might try sanding down the leading and/or trailing edge of the blades to see if I can quiet them...
The block started off as a Rotor block but I lack the finnesse
, I ended up just using the drill (normal drill in a bench adapter, tis' wobbly!!) to 'mill out' the whole inside area, nice pattern of dimples on the bottom
. It's OK though I wanted them to be low restriction blocks for the GPU and NB so I can run them in parallel after the CPU...
At a guesstimate the NB & GPU will each be 2inches sqare and the CPU will have to be 3x2.5 inches to fit the mounting holes. I've had to put this on hold abit as well as my mobo(KX7) is fugging up, it's only stable at 133FSB so I've had to borrow my bro~inlaws credit card to get a new NF2...
__________________________________
I use 13mm 1/2 tubing
...