Quote:
Originally posted by JFettig
somethign ya might want to try jaydee, is making those cross pins, in a slightly larger area(.625^2) and opening up the cavity, and adding some jet inpingment. either a 3/16inch single jet or a few (6) 1/16inch jets, your origional multihole jet had way too much flow to do any jet inpingement, and it slowed the flow too much with all the surface area in the top...get what Im saying?
It might work
Jon
|
No.
Jet will not work, are we looking at the same block?. Not making the area larger. It is 1/2" wide for a reason. Whioch BTW is plenty. Measured a XP core lately? when the hammers come out with a heat spreader then it will change if I am still doing blocks then anyway...
Quote:
as to where you have the screws for holding on the top, 4 will do great, just move them out toward the edges a little bit, and closer to the mounting holes, just not too close....
also, i bet you could cut an oring groove with that machine? dont ya think? 1/16inch O-ring?
Jon
|
and no and no.
4 screws do not work with silicone. 6 screws work well and only takes an extra 2 mins to drill and tap. I made the complete base with the holes drilled and tapped in 30mins.
O ring groove? Kinda hard to do with V shaped bits eh? wouldn't work.
O ring will come in the future when I can get my mill setup somewhere where I can use it. Then I can drop it down to 4 screws if I feel like it but will probably stick with 6.
I made a set of goals on what materials to use and how I was going to do things. Not to open to suggestions but don't mind hearing them.
