Quote:
Originally posted by hara
Jaydee, have you got a commercial block to compare your results to.
BTW nice job on the blocks you're doing with an engraver
One suggestion: try combining the maching done with an engraver with the machining done with a CNC. The sky's the limit. Can the engraver mill deep in copper ? ~4mm
|
Never had a reason to buy a commercial block.
Yes it will but with the V shaped bits it wouldn't do any good. there is no need to combine the two I found a 10,000RPM pully for my mill so it will be able to do similar stuff this engaver can. Only advantage the engraver has over a mill is speed.
Also that test had the probe up against the CPU core and insulated from the base of the block, guess the silicone is hard to see under it? Doesn't matter much though. Once I get the final version done it will be sent to BillA. Still have a little tweaking to do. Got the O ring sizeing done today aswell. It will be a few months before anything else is finished.