Quote:
Originally posted by hara
The base could be strengthened with a copper/brass top.
I'm no expert on tooling but if the base is first milled and then engraved the result could be this (mad paint skillz):
This design would certainly be much more difficult to manufacture in your case 
|
Yeah I see what your saying. Isn't going to happen though.
Also on the brass/copper tops, to heavy and it would add 40% more to the cost. Base doesn't need to be any thinner and the pins don't need to be any higher, not in the REV. 4.0 soon to be 5.0 anyway. This is the "Low Cost" block, not the performance block BTW.
