Quote:
Originally posted by bigben2k
10 deg below your registered CPU temp would be awsome. Under load, 15 degC would be good.
I'd look into putting together pHaestus diode reader, if it's possible (mobo limits), and if you're interested.
|
i picked up a digital aquarium thermometerr on my way home.
i insterted the aquarium probe into my fill/bleed line.
then attached a secound probe to the side of my silicon tube on the same side of my heater core.
while the system was switched off.
room 20C
water in tee line 20.4
tube 20.3
cpu probe on side off heat spreader 23.1
this should meen both temp probes will be close readings.
i then moved the temp probe attched to one of the outlet tubes of the water block.
after 30 mins idle.
room 21
water in tee line after the heater core 21.1
probe attched to one of the outlet tubes of the water block 23.0
cpu probe 25.4
bios temp 35
mother board temp 22
after 30 cycles of motherboard montor cpu test using the burnin wiazrd.
room 21
water in tee line after the heater core 22.7
probe attched to one of the outlet tubes of the water block 24.4
cpu probe 28.1
bios temp 38
mother board temp 24
and after sitting idle for about 1 hour
room 21
water in tee line after the heater core 21.5
probe attched to one of the outlet tubes of the water block 23.4
cpu probe 25.8
bios temp 35
mother board temp 23
i am running pump > cpu > rad