Quote:
Originally posted by bigben2k
Oh yes!
Since the minimum order for 1/2" thick polycarbonate at McMaster was a 12" by 12" sheet, and it cost $17, I opted to get 2 sample sheets of 1/4" by 6" by 6" ($1.99 ea.), and glue them together.
Since my Devcon plastic Welder is cream colored, it would nullify the clear effect.
So I'm going with IPS Weld-On #4. It also contains Methylene Chloride (VERY NASTY!), which I can then use to seal the cracks in the drilled holes.
Voila! 
|
I use the stuff all the time at work. Have about 1/2 thing of the 4oz can left. Make sure you clmap the hell out of it when you put the peices together. I tried using it for a res and it failed miserably because I couldn't clamp it right. The stuff is just like water consistancy wise to make sure you don't get any on the parts you don't want to turn blury.
Also I thought that stuff was for acrylic only?
