Quote:
Originally posted by bigben2k
Thanks for the tip!
I was thinking about putting a weight on it.
Otherwise, the polycarb sheets have a plastic film on each face, so I'll leave that on.
It's great for acrylic I'm sure but check it out
I was tipped of by blackeagle here
|
Cool. The studd is pretty good. If applied right the material will break before the joint will. We use it to put acrylic bases on the acrylic plaques we laser engrave. #16 is thicker and is what I would use for resivors but it is near impossible to get any as no one will ship it to WA because of the hazordous matarials BS.