Quote:
Originally posted by Mark Larson
Very nice, but looks a trifle crowded. Is that 1/2" ID tubing going to the blocks?
No clamps? 
Good job 
|
Thanks!
Yeah, it's tight in there but I didn't want to do things like rip out drive housing and such. I'm willing to cut holes in my side panel but that's about it. It's 3/8" tubing in the system. I was barely able to route the 3/8" tubing, having the rad so close to the blocks (and dual processor to boot) I don't think 1/2" would have made it. The pump's inlet and outlets are 3/8" so it works out.
The "Y"s didn't really need clamps. Some of the other connections did.