View Single Post
Unread 04-21-2003, 09:46 PM   #1
V12|V12
Cooling Savant
 
V12|V12's Avatar
 
Join Date: May 2002
Location: Ohio-State! <--Money Hussle! SUCKS
Posts: 292
Default Phase-Change System List

Hey all, after talking with a buddy and the success of his phase-change setup, the challenge has now been set in my mind and I'm thinking about moving from my now tweaked Water setup, to Phase-Change... Could one or more of you Phase-Guru's help me out with a simple parts list I'll need? I'm not looking for super low temps, just something around Single-digit full loads on my XP 1600@1.814@1.792v (defualt setting) ~85W...

I few hours back, I scoped out a nice apartment size "micro" fridge and it should be running fine, I'm going to grab it up and check it, to see if it runs... So far I know that I'll need:

BTW-I'm just looking for a cheap setup, nothing super....

1)Compressor

2)Radiator/ (can I use a Heater core?)

3) 1/4-3/8" soft copper tubing ~ 15ft

4)AC thick rubber hose (Can I use some nylon reinforced Vinyl?)

5) Coolant (I'm going to be using propane in place of the freon)

6) INSULATION! Neophrene.... what works best?

...I'm getting the rest together later, thanks all!
__________________
XP 1600+ AGOIA-Y (GreenLabel, UNLOCKED!@/ NF7-S 2.0/ PC 2700 DDR
10.5*172FSB(1806/ 1991 high), Vcore 1.792...@84.95Watts
--86' Chevette Heater Core
--1/2" Vinyl tubes
--Via1300-Stealth Mod(QUIET!)
---Home made copper-tube block
---PVC small internal res
V12|V12 is offline   Reply With Quote