1. HC dimensions for Blackeagle:
Finned area: 9.5" high x 2" thick x 6.1" wide. 11" overall height.
Fanage: 2 Panaflo H1As on nexus fan controller. Fans will draw air through HC.
Shroud details:
sheet alum. from Ace Hardware. Cut outside cuts w/ Fiskers scissors, fan holes w/ dremel/cutting disk. (octagon shape works fine if done right)
1/8" weatherstripping will be used for fan gasket.
Sides of HC are filled to give flat surface for mounting velcro to hold shroud / fans.
Whole assembly supported by screws through HC out through front of case.
sides riveted together: bent long dimensions first, then rivet tabs, then narrow dimensions, then bent over sides of fan holes(left metal on 8 sides to bend under for support, etc)
Working on finishing up reservoir and cpu cooling subsystem by end of next weekend? :shrug:
(Note: pictures are fuzzy due to low resolution to make pictures more bandwidth friendly (No, not like the "first ones"
)
