I don't know the C/W of the maze3, and I'd trust no~one but BillA for it!. AFAIK the main selling blocks all perform pretty much the same within a degree of each other, I 'think' the new swifty is better though...
I'm using an Ehiem 1250 pump...
I'd like to see the BP thinner, also the fins shorter maybe?. Also I'd like to optimise the inlet if possible so there's a slot 2~3mm wide the width of the fins, there's no impingment happening at all at the moment...
Would you like me to send you the maze3 block?. You'd have to bodge a hold down for it though, should be easy enough, just an ally(even wood!!) plate with a slot/holes cut out for the inlet/outlet and holes drilled for the P4 mounting holes. IIRC the P4 holes clear the body of the maze3 anyway, the poly top usualy overhangs the body and the holes are in that...
I can let you have a peice of ally plate as well to use if you hav'nt got any...
PS, you'd have to make sure the maze3 clears the sockets 'lip', the inlet has to go to the right, the outlet to the left(or the side with the lever)...
|