Pro/Forums - View Single Post

mad mikee · 05-04-2003, 09:49 PM

Must install photoshop b4 new posting so that I can crop
As some may have garnered my attempt to get something other than 120mm panaflo H1A (hey they looked good as allelectronics when I saw them :shrug: ) had less than ideal results.

Then I found out that the MJ1200 is about 5 times as loud as my old trusty (and now back in the saddle) eheim 1250. (another is on the way for the GPU/NB loop).

After the delay of remaking the 'inlet expansion' for the 1250 (and yes I bought spares for the impeller cover and locking ring) I am testing the CPU loop once again and here is some explanation for the pic below:
1. Upper T is to allow the last bit of air out from the rad tank (easier than turning over whole case)

2. Tube going to lower right corner allow easy drainage.

Took about 10 minutes to get the last air out of the rad. Running test in the dungeon as I type.

Got the rough plan for GPU/NB loops figured out.

05-04-2003, 09:49 PM	#39
mad mikee Cooling Savant Join Date: Oct 2001 Location: US of A!!!! Posts: 146	I hate reality (or back to eheim and panaflo) Must install photoshop b4 new posting so that I can crop As some may have garnered my attempt to get something other than 120mm panaflo H1A (hey they looked good as allelectronics when I saw them :shrug: ) had less than ideal results. Then I found out that the MJ1200 is about 5 times as loud as my old trusty (and now back in the saddle) eheim 1250. (another is on the way for the GPU/NB loop). After the delay of remaking the 'inlet expansion' for the 1250 (and yes I bought spares for the impeller cover and locking ring) I am testing the CPU loop once again and here is some explanation for the pic below: 1. Upper T is to allow the last bit of air out from the rad tank (easier than turning over whole case) 2. Tube going to lower right corner allow easy drainage. Took about 10 minutes to get the last air out of the rad. Running test in the dungeon as I type. Got the rough plan for GPU/NB loops figured out. __________________ His PCV2000 DFI ULTRA D (SLI Modded just because) 4200 x2 @ ~ 10 x 260 /1.49 Vcore , G5 + PA160 + 150mm Papst@5V + Maze 4 GPU + mcp350. Temp 36-37(load-2 x D20L) 2x1GB Ballistix PC4000, x800xl 256m, 74G rap + 160G Hitachi SATA , 21" mit/nec 1920x1440 Crt + 19 Neovo F-419 1280x1024 LCD, OCZ Powerstream 600 Hers: (my beloved who lets me do all this) LianLi PCV1000, SD3700 @ 9x300, 1GB GBLA, 250+ 120 SATA, X700pro, 19" Neovo F-419 LCD, another OCZ 600 Last edited by mad mikee; 12-28-2003 at 08:01 PM.