Quote:
Originally posted by qwerty57
well last night I did some testing and found that I had -19c on the block out of the case running 10-15c chilled water through it. this is my 172w (24v)tec at 12.6v.. so results are good but Im going to do this now.
block
mcw40 non tec copper bottom
pelt hot side
pelt cold side
mcw40-t stock copper bottom
gpu
|
I've been curious about the clamping pressure issue with the Swiftech 'wet TEC' blocks.
I'd suggest you try it both ways:
Hotside -> copper -> water
Hotside -> water
I'd be very interested in knowing the results of the comparison.
Do you have a torque driver? How are you going to control the amount of clamping pressure?