well after 2 long days i have a version 3 of the block made form the same base as i am still waiting for the thermaltake base but will make a second version of this to test for the gap is the center.
here you can see the inlet squashed at the end to make a jet.
inside you get a better vie of the jet.
the base is 2.5mm thick with 4mm fins and 1mm channles cut between them leaving 1.5mm above the cpu core.
It took over 3 hours on a belt sander to take off 1mm of the base
i am waiting for a new power supply for a test rig i have put together and i will test this block againt a maze 3 i have thanks to maddogme.
it wil also fit amd boards and will soon have a amd mobo to test it again with the maze 3.
maddogme hope everything is ok. I made a p4 hold down for the maze 3 should work very well. I also have a set of danger den springs on the way.
BE this is made with the top you sent me i cant thank you enough.
what a shame billa is not testing any more i was going to send one of these to him once i am happy i cant improve on it. oh well
congrats on the job billa
Lee