Quote:
Originally posted by bigben2k
Ok, I didn't see that logic, until you explained it. It would be nice if you could run a plastic prototype through flow testing, then figure out if it's really needed. Otherwise, it only adds to the pressure drop across the block, and unless you plan to use a hefty/beefy pump, you might be missing out on some extra performance.
Yes, the extra height lowers your flow speed, which decreases turbulence.
|
As I have said previously, this block is, very likely, never going to be made. A person who this block was intended for has taken it to the workshop and people there told him that it is too much trouble to machine it, so I made another, much simpler design.
I don't have enough courage to show you guys that design....
Could you, please, make it more clear for me what you mean when you mention flow testing.