Quote:
Originally posted by #Rotor
Pardon me for saying this of my own design, but that block of yours just ooze extreme high performance out from everywhere.
|
A Word from a Master.
Thx!
wywywywy: yes, silicone will be the sealant. Think I'll have enough free time today to sand the block and seal it. Gonna try it this weekend (I hope
)
MDM: CPU block is 'in progress', the idea was to try to drill channels with 1 mm bit, but it's just too hard on crappy drill (drill bits just snappin' like hell, even on the highest rpm that drill can achieve:shrug: ), so dremelling it 'by hand' gives less adorable result, and even less precision (especially in depth of channels). At the moment, depth of the channels is 3 - 3.5 mm, which is enough to try it (copper plate is 5 mm thick), but just looking at the block, think it's gonna be Restictive, with capital R.
I still haven't tried to polish the plexy edges with my pencil torch, and copper needs sanding. I'll try to finish it and try it soon...
Here are the drawings for all three layers, top and middle is 8 mm thick plexy (no lexan here
), and base is 5 mm thick copper, everything 80 x 50 mm: