Pro/Forums - View Single Post

dearkook · 05-15-2003, 04:47 PM

I am at the stage in my WC project were I have to buy a pump I've not heard anything bad about www.customaquatics.com so I will be ordering from there. I have a single-pass HC 9-1/2 X 6-1/8 X 2 with 2 128cfm 120mm fans pushing and 2 pulling air with a shroud on both sides. The system will be 1/2" tubing and connectors with a CPU & GPU block(Undecided but will most likely be medium flow blocks). I'm looking at the following pumps.

IKMD15RLT
IKMD20RLT
IKMD20RLXT

I'm not really sure which to get I've done plenty of looking and found the general opinion is I should be fine with the MD15RLT. I just want to be sure so I'm asking what everyone thinks.......

Thanks
Kook

O and are these all US volt pumps? 110v? And these are all about the same size correct?

05-15-2003, 04:47 PM	#1
dearkook Cooling Neophyte Join Date: Jun 2002 Location: Columbus Posts: 8	Help me pick my Iwaki Pump I am at the stage in my WC project were I have to buy a pump I've not heard anything bad about www.customaquatics.com so I will be ordering from there. I have a single-pass HC 9-1/2 X 6-1/8 X 2 with 2 128cfm 120mm fans pushing and 2 pulling air with a shroud on both sides. The system will be 1/2" tubing and connectors with a CPU & GPU block(Undecided but will most likely be medium flow blocks). I'm looking at the following pumps. IKMD15RLT IKMD20RLT IKMD20RLXT I'm not really sure which to get I've done plenty of looking and found the general opinion is I should be fine with the MD15RLT. I just want to be sure so I'm asking what everyone thinks....... Thanks Kook O and are these all US volt pumps? 110v? And these are all about the same size correct? Last edited by dearkook; 05-15-2003 at 04:52 PM.