[g.l.amour]

congrats on some insane blockage...

well, since i'm working with about the same tools as you are (hmm, how could that be?) i can affirm the craftsmenship ;-)

but i think most of my congrats must go to that beautifully made plexi top. i can almost be sure that that piece proved to be the most difficult (it was for me). the copper is like a cakewalk compared to plexi, nm if u do it slow or fast, it is very easy to make it "explode" when the drill breaks out. the clamping makes it a hit or a failure.

dunno about the performance u will be getting, let me know. lets say, how much it went below your first rotor cpu block.

cheers, and a hail to the CROverclocker