Quote:
Originally posted by Ion
I made mine ½" inner diameter and 5/8 threads. But then I made my block too, so the fit wasn't a problem. =)
|
My last bunch of blocks have all been single inlet double outlet. There just isn't enough room for anything larger than 1/4" NPT threads. They take up a strong 1/2" by them selfs. Then leaving gap for 1/8" thick hose which is another 1" adding ion for hose clams aswell. That takes up 2.5". That leaves 1/4" on both ends for the 1/8" O ring groove. Comes out just right.
