Pro/Forums - View Single Post

CheeseBall · 05-19-2003, 10:31 PM

I opened up my Antec True550W today, and there are 4 male connectors on the switch. 2 ground and 2 "+" I think you call it. The 2 wires going to the switch are connected by going through the holes in the center of the male connectors and then being "soldered" to the stripped wires. The ONE wire goes through the TWO connectors (the grounds are in a column and so are the +s). So it will be tough to get some female connectors over them to power my pump. Has anyone done this w/ a similar PS? I guess I was just expecting something different and now I don't know what the best thing to do is.

If I decide not to try it I guess I will just rig up a switch and relay.

Thanks for any insight.

05-19-2003, 10:31 PM	#1
CheeseBall Cooling Savant Join Date: Jan 2003 Location: Colorado Posts: 176	Powering pump w/ PS switch I opened up my Antec True550W today, and there are 4 male connectors on the switch. 2 ground and 2 "+" I think you call it. The 2 wires going to the switch are connected by going through the holes in the center of the male connectors and then being "soldered" to the stripped wires. The ONE wire goes through the TWO connectors (the grounds are in a column and so are the +s). So it will be tough to get some female connectors over them to power my pump. Has anyone done this w/ a similar PS? I guess I was just expecting something different and now I don't know what the best thing to do is. If I decide not to try it I guess I will just rig up a switch and relay. Thanks for any insight.