I think I'm gonna re-label my watercooling website - How to Over-Engineer Anything Without Really Trying.
In an effort to create a super-clean duct installation, my new radiator duct design resulted in almost 50 separate pieces *just* for the radiator section. This doesn't count the 50+ 6-32 machine screws that will hold it together.
The drive bay section is a lot less complex holding stead at just four pieces.
I haven't even gotten to the point where I'm ready to talk about the span section. I started looking at receipts, and I started this whole adventure back on April 4th. I've been working on this for almost two months!