Pro/Forums - View Single Post

jaydee · 05-22-2003, 08:27 PM

Now that I have some time. Why I think the block is a POS.

1) The channels are not milled into the copper base making all the milled out surface areas near useless being the heat isn't going to transfer well to the AL especially being it is anodized.

2) The channel design is kinda dumb. Why would you merge the water from 2 sides into one and then split again? Sever excessive flow restriction for a loss in performance.

3) Way, way, way over priced.

Also those monster blocks on the side are made of Delrin Plastic. Which isn't a bad thing really. I use the stuff at work sometimes. Very strong stuff.

More info: http://www.comservercom.com/product1.htm

And the home page of the manufacturer. Notice the [H] case on the front page. Already lost points for that! http://www.comservercom.com/

05-22-2003, 08:27 PM	#5
jaydee Put up or Shut Up Join Date: Dec 2001 Location: Spokane WA Posts: 6,506	Now that I have some time. Why I think the block is a POS. 1) The channels are not milled into the copper base making all the milled out surface areas near useless being the heat isn't going to transfer well to the AL especially being it is anodized. 2) The channel design is kinda dumb. Why would you merge the water from 2 sides into one and then split again? Sever excessive flow restriction for a loss in performance. 3) Way, way, way over priced. Also those monster blocks on the side are made of Delrin Plastic. Which isn't a bad thing really. I use the stuff at work sometimes. Very strong stuff. More info: http://www.comservercom.com/product1.htm And the home page of the manufacturer. Notice the [H] case on the front page. Already lost points for that! http://www.comservercom.com/ Last edited by jaydee116; 05-22-2003 at 11:05 PM.