an excerpt from the update download:-
Quote:
"over time a coil was getting quite hot and warming up associated components. This was in the area where all the ATX and device power wiring is soldered to the PCB. To help with this I decided to thin out this wiring in two ways. One was to replace all the multiple +5v, +12v and Ground wiring with much thicker single wires, (40 amp rated wire design for nicad power packs used radio controlled model cars). It was then spit to the normal wiring outside the PSU. I also removed the other unused power connectors, like the P4 one, and the old AT type".
|
I've since put the p4 connector back as the nforce 2 mobo has a P4 type connector