Awww, back from the lake. Different one this time but still caught some big bass. Just the perfect timming I guess. They are hitting the shallows and getting into their spawn beds. If you cast anything even close to their spawn beds they nail it. In the kayak you can get within 10ft of them without spooking them. Then it is a matter of a making a good cast and it's on! Another month and it will be back to the smaller one's on the shoreline and will have to go deeper or wait untill evening to get the bigger one's.
Yep, I was a spamming bitch last night. Not intentional but posts came up that were worth replying to...
Well anyway... Ben I got the files converted to .dxf thanks to Zymrgy. Now I have to load up ACAD2000 again and see if I can make the tool paths. It is odd when I open the .dxf in Correl or Solid Works all I see is a side view and I cannot figure out how to rotate it to the front view. I know my way around ACAD2000 better than anything though (which isn't saying much) so maybe I can figure it out in that.. Aww the learning process....