Scratch my last post. The drawings are in .dxf form (thanks to Zymrgy) and seems to be editable in ACAD. I finally got a top view so drawing the tool paths should be easy. I got a simulation program with my mill which shows a preview of what ever it is cutting as it would be happening on the mill so I should be able to get it all setup by the time i get the mill itself set back up. Only issue I may have is lack of RPM. My mill tops out at 2,800RPM so I will have to severly drop the feed rate. I hope I can get it to run slow enough. If not i will buy the 10,000RPM pully from Sherline that is made for the mill.
