I was just looking at it....I could program the thing easily using the G-codes from your link. You might have to manually edit the program, but I can help you out with that also. You are limited on you rpm & stuff....but I can make a huge program...light depth of cuts, slow feed rates, ect. the thing might take 8 hous to run....but then its in your garage...just get the thing going...play a round of golf...come back, check on it..go to bed...it the morning, viola. This ould only be for the detailed center area...obvioulsy for the holes & stuff you would have to be there to set up tools & such.
|