Pro/Forums - View Single Post

MadDogMe · 05-30-2003, 04:24 AM

I was going to sugest putting a slit across the middle in my last post but thought the centre 'circle' was too small to warrant it...

I was'nt being derogatory with the WW killer comment, I really do like this block, very inovative and think it'll perform well (better than Maze3 and probly better than the 4, yours is better detailed). It's a shame about DD's timing though, is'nt that always the way though? :shrug: ...

I'd be interested in a block with 12mm inner diametre barbs made from some copper pipe, are the ones on there threaded or epoxied into the polytop?...

05-30-2003, 04:24 AM	#29
MadDogMe Thermophile Join Date: Aug 2002 Location: Just shut up ;) ... Posts: 1,068	I was going to sugest putting a slit across the middle in my last post but thought the centre 'circle' was too small to warrant it... I was'nt being derogatory with the WW killer comment, I really do like this block, very inovative and think it'll perform well (better than Maze3 and probly better than the 4, yours is better detailed). It's a shame about DD's timing though, is'nt that always the way though? :shrug: ... I'd be interested in a block with 12mm inner diametre barbs made from some copper pipe, are the ones on there threaded or epoxied into the polytop?...