Quote:
Originally posted by pHaestus
jaydee:
Two things
(1) I need to get the system up and running reliably first aand test out a few blocks I have now. I have about 4 blocks from mfgrs that I have not yet tested in fact.
Once this is done then
(2) I really prefer to test DIY blocks rather than the commercial ones, but where does the fact that o/cers is also buying equipment to do this fit in? JoeC has a die simulator already (though I get higher temps with the internal diode from my CPU) and they have a larger reader base as well. Should I just leave the DIY block testing to them?
I haven't sorted out (2) in my head yet honestly. Oh well maybe with (1) finished I can come to a good decision on where to go from here.
|
I hear ya. I am in no hurry. I don't care about it being seen by any other site. If it tests well I might gear up and make a few. Just about every bit of thought that went in and is going into this block came from my learning here over the last year. I am only going to show REV. 5 and 6 off in the forums here as this is the only place I get decent feedback on anything. Not to worried about an "official" review. We can get into this later though.