Pro/Forums - View Single Post - Help with adapting DTek block to hole-less board.

Jerky · 05-31-2003, 12:06 AM

Recently I got a new board that comes without the 4 mounting holes. Due to the size of the Spir@l block, a custom clamp is going to have to be made so it can use the 6 socket lugs.

Spir@l: 3" x 2.5" <--- This causes the problem.
DD Maze3: 3" x 2.125"

However, a good design doesn't seem that obvious. Has anyone seen an adapter/design etc. that can be used in this case?

I'd love to use my Spir@l on my new board, but can't because I can't figure a good way of mounting it.

05-31-2003, 12:06 AM	#1
Jerky Cooling Neophyte Join Date: Sep 2002 Location: Toronto Posts: 12	Help with adapting DTek block to hole-less board. Recently I got a new board that comes without the 4 mounting holes. Due to the size of the Spir@l block, a custom clamp is going to have to be made so it can use the 6 socket lugs. Spir@l: 3" x 2.5" <--- This causes the problem. DD Maze3: 3" x 2.125" However, a good design doesn't seem that obvious. Has anyone seen an adapter/design etc. that can be used in this case? I'd love to use my Spir@l on my new board, but can't because I can't figure a good way of mounting it.