Pro/Forums - View Single Post

leejsmith · 06-03-2003, 04:11 AM

I am going to make a couple of tops to go with the 1.5mm base.

first keeping the squashed inlet but one with 1mm and one with 3mm jet at the end.

then i will make a 2 piece top very simular to the white water. the quashed inlet will increase velocity but it's a smooth transition. with the jet plate it will create turbulance as it hits the smaller jet hole before it enters the base fins.

I am not too happy with the copper tubes as inlets. They work very well but the araldite instant i am using goes a bit soft where it's in contact with the water. I might cover the areas after it has set with silicon to protect it.

06-03-2003, 04:11 AM	#217
leejsmith Cooling Savant Join Date: Mar 2003 Location: notts uk Posts: 408	I am going to make a couple of tops to go with the 1.5mm base. first keeping the squashed inlet but one with 1mm and one with 3mm jet at the end. then i will make a 2 piece top very simular to the white water. the quashed inlet will increase velocity but it's a smooth transition. with the jet plate it will create turbulance as it hits the smaller jet hole before it enters the base fins. I am not too happy with the copper tubes as inlets. They work very well but the araldite instant i am using goes a bit soft where it's in contact with the water. I might cover the areas after it has set with silicon to protect it.