so i made the tops and found that 2mm and 3mm squasjed tubes gave the same results.
1mm squashed tube gave put .5C back i think thats due to this inlet taking 65 seconds to fill a 5l container compared to 30 on all of the others when i did a flow test.
and last a 3mm jet plate based on the WW jetplate and this took another .5 of my best results so far.
looking at the jests in action you can actualy see turbulance in the ww style jet where as with the squashed tubes you dont.
i am going to experiment with the jet plate and make another top.
After some tips from cathar i might reduce the width of the finned area so it's not covering the whole p4 heat spreade but still keeping the length so instead of 30x30 i will try 30x20. This should make the jet plate more effective.
anyway my mind doing overtime at the moment on cathars v2 tube cup block. taking 2C of WW is awsome drool:
|