the ww style jet plate improved the temps buy .5C so thats 1.5C better than the maze 3. Maybee with a tweeked jetplate and or the smaller finned area it will improve.
WRT the tube cup block.
I have the copper tubes allready and i am working on a plan at the moment.
It wont be as small as cathars my drill press is pants. i have 2mm OD copper tube and was thinking of 3.5mm cups with 1mm between each cup but i will need a very good drill to be so close on the base plate.
From reading here i will need very high rpm with small drill bits on copper.
my other problem is getting copper for the base i do have a second thermaltake base that i could use but it's getting expensive to keep using a £20 cooler to experiment with.
i dont expect to get to the same performance but to be even close to WW would be wicked.
|