Quote:
|
the argos piller drill looks good.
|
I wouldof' gotten one but I've got a 'circa 1970' B&D strap on jobbie!!
(with adjustable RPM drill
)...
Quote:
|
know where i can get milling bits or drill bits with flat ends ?
|
Not offhand but there'll be loads be online for sure. Biggest toolseller you can find would be the best bet...
Quote:
|
would a copper peice 80mm x 160mm x 10mm be ok ?
|
YOU BET!!...
Quote:
|
what do you think about selling the cases with the water kits in them at a local shop ?
|
So much depends on local demand, how much trade the shop gets. Selling through a shop might be too much legal wrangle as well :shrug: . Maybe let them show an example and take orders (give them a cut for doing it[
SMALL ONE!! ]). I would'nt think about the mill for it though unless it took off, a Swiftech open block design would do to start, you could make one out of 2 or 3 peices(dimple bottom/plexi top), or factor the price of a retail 'block of their choice' into the cost. Think about it before you make any choices though. Have you spoken to the shop owner yet?. They might not like the idea of selling a 'buy as seen' product with no after support (which it would HAVE to be, water & electric & joe~sixpack don't mix :shrug: )...