View Single Post
Unread 06-11-2003, 12:51 AM   #81
Althornin
Cooling Savant
 
Join Date: Dec 2002
Location: Houston, TX, USA
Posts: 221
Default

Quote:
Originally posted by GTA

If you put a 45x45mm pelt on this block, you'd actually be able to see part of the peltier sticking out of the side of the block, not only not under the cooling section, but not even touching copper.

The design is easily adaptable though, just add more circles.
ah, i wasnt aware the block was that small.
Of course - it would be good for pelts if you made it larger (more circles).

You are using a lathe, right?
I'd imagine that is much cheaper than machining.
Althornin is offline   Reply With Quote