Quote:
Originally posted by Blackeagle
Lee I like your idea of building custom built rigs. I of course have no idea what the market is like over there. MadDog is right about wait to see if the first couple sell before shopping for mills. (Unless this is just a prime excuse to buy the mill you want anyway! )
And thanks much for the pin sink, looking forwards to playing a bit with it.
|
it sounds like a good idea but i have to agree with MDM regarding the people that would buy one and when they make some mistake and all there components get wet who are they going to blame and expect to sort it out ? Me.
I have some other ideas but more on them later.
Anyway my new toys as the girl firend calls them arrived today.
one very nice looking cros vice and 3 endmils.
problem one the cross vice is alittle to big for my drill press.
problem 2 my drill that fits in the drill press has only 1 speed setting and the end mills just reck the copper at that speed.
what rpm do i need for the end mills. I need them to make the bottom of the cups flat after they have been drilled.
Plus i was thinking of using a 10mm endmill to make a chipset and vid cooler by milling a simple maze into the 10mm copper i have like the danger den z chipset blocks.
on a positive side the one turn of the cross vice x -y handels = 3mm so now i dont need to punch the pattern and can make a smaller design with some smaller tubes have.
what a shame i promised the GF i would spend this after noon with her Doh !!!