Quote:
Originally posted by Zymrgy
I know mine...a abit KT7A ( yea I know )
|
I got a half dead one of those. Droped something on the south bridge and now the hard drive controller doesn't work. That was a good board to. Loved to OC Durons on it. Aww the good ol days.....
No I don't think we are after a standardized testing equipment (although that would be nice) but I think if your going to be taken seriously it at least needs to be a thermocoupler factory built or at very least properly calibrated if self built. And then use a standardized testing method which I assume someone is working on?
Use Artic Silver thermal epoxy if your concerned about the thermal transfer.
Should be able to remove the epoxy if needed although you may need a new thermocoupler.
You might even get away with silicone sealant. I will have to experiment with it. Should have my new thermocoupler/meter Monday.