Quote:
Originally posted by Cathar
How does one route the tubing to the inner barb with the outlet in the way?
How much space would be required to do so?
What do you do with the 1" tubing? For how long is it run?
|
1. The tubing to the inlet runs inside the tubing for the outlet.
2. Not sure I get what you mean there.
3. Personally, I'd run the 1" tubing just far enough so that it was out of sight in the case. Admittedly, the main purpose of this inlet/outlet system is to look cool
I'm just not keen on the inlet/outlet look on the Cascade. I'm probably very much in the minority though. I think that if it wasn't modelled so much on the WW design, it could be made to look a lot better. Obviously no dispute that it works, but aesthetically, its not a patch on your WW block.
Just my 2p again, feel free to tell to piss off and make something better myself if I don't like it
