Quote:
Originally posted by Blackeagle
At: www.leakycar.com
Check out the rad #2-342 which is large enough to allow the mounting of dual 120mm fans (on both sides if you wish or course). This rad isn't hard to set up for computer cooling. Just cut the long tubes down and make a shroud.
|
The mesurments for that heater core is
9-1/2 x 6-1/8 x 2
I have exacly 10" clearence in the YY cube i'm going to get and was wondering if the mesurments listed are for the core only or for the petruding tubing as well?
Thanks