Pro/Forums - View Single Post - BIX 2 in Lian Li PC-62

pakman · 07-06-2003, 12:33 AM

I just installed a BIX2 into a lian li PC-7 which has the same dimensions as the PC-60's. One place it will fit INSIDE the case is on the top panel. also note you will lose the 2 top CD drive slots. But becareful, depending on where your CPU waterblock sits on your mobo, the tubing running from the BIX2 may be obstructed. I currently have maze3 on a epox 8rda+ and there is just enough room for the tubing from the BIX2 to pass around the mounting hardware on the waterblock.

I am afraid that is really the only place you can fit BIX2 on that case. But it does make for a very sharp, clean look without ruining the lian li's looks...

I can post a pic of the install if your interested.

edit: you may also have to mod your PSU so the wires come out from the bottom instead of the back so that it clears the bix2. but then the pc-62 is 10cm longer so maybe this won't be an issue.

07-06-2003, 12:33 AM	#2
pakman Cooling Neophyte Join Date: Jul 2003 Location: WA State Posts: 76	I just installed a BIX2 into a lian li PC-7 which has the same dimensions as the PC-60's. One place it will fit INSIDE the case is on the top panel. also note you will lose the 2 top CD drive slots. But becareful, depending on where your CPU waterblock sits on your mobo, the tubing running from the BIX2 may be obstructed. I currently have maze3 on a epox 8rda+ and there is just enough room for the tubing from the BIX2 to pass around the mounting hardware on the waterblock. I am afraid that is really the only place you can fit BIX2 on that case. But it does make for a very sharp, clean look without ruining the lian li's looks... I can post a pic of the install if your interested. edit: you may also have to mod your PSU so the wires come out from the bottom instead of the back so that it clears the bix2. but then the pc-62 is 10cm longer so maybe this won't be an issue. Last edited by pakman; 07-06-2003 at 12:43 AM.