Pro/Forums - View Single Post

jaydee · 07-07-2003, 02:39 PM

I am going to pick up some 1/16" endmills and see what I can do with them on my mill. I should be able to make these jets pretty easy on it. I am sticking with 9-13 jets though instead of the crazy amount Cathar and the Cathar clones are. I think I can do pretty good with 13 jets total. That will easily cover the Die and then some. And with less and bigger jets flow rate is increased which is good for smaller pumps. Lots of work/experimentation left to do though.

I love this design as all the milling is done in plastic. I might even be able to get away with milling these in my apt. as the noise should be minimal.

07-07-2003, 02:39 PM	#7
jaydee Put up or Shut Up Join Date: Dec 2001 Location: Spokane WA Posts: 6,506	I am going to pick up some 1/16" endmills and see what I can do with them on my mill. I should be able to make these jets pretty easy on it. I am sticking with 9-13 jets though instead of the crazy amount Cathar and the Cathar clones are. I think I can do pretty good with 13 jets total. That will easily cover the Die and then some. And with less and bigger jets flow rate is increased which is good for smaller pumps. Lots of work/experimentation left to do though. I love this design as all the milling is done in plastic. I might even be able to get away with milling these in my apt. as the noise should be minimal.